Speeduino EFI Shield Mega 2560 Pro Rev 1.4a By Don
ECU / Speeduino / Hydrogen Hot Rod — This is the engine-management layer of the Hydrogen Hot Rod stack — the board that turns an Arduino Mega into a real, sequential, closed-loop ECU capable of running a hydrogen or dual-fuel engine.
Rev 1.4a is a later revision than the one originally published on PCBWay. It adds an on-board barometric sensor option and jumper points that let you configure the injector driver section for either two or four channels, so the same PCB covers a 4-cylinder sequential build and a smaller batch-fire setup without cutting traces.
The driver section is built around four IRL3705Z logic-level MOSFETs for the injectors with an IRF5305 P-channel device on the high side, and each channel is protected with 1.5KE36CA TVS diodes against the inductive kick you get from low-impedance injectors. Two resettable polyfuses (RXEF090 on the main feed, RXEF050 on the sensor rail) and a 22V MOV on the input keep a wiring fault from taking the Mega with it — worth respecting, because hydrogen builds tend to see more harness rework than a petrol conversion.
Everything leaves the board on a single DB37 connector, which is the standard Speeduino harness interface and keeps the ECU swappable between test mule and vehicle. Sensor inputs are conditioned with 10k pull-ups and 100R series resistors on the ADC lines; the 22uH inductor and the 0.001uF filter bank on the analogue front end are there to keep ignition noise out of the MAP and CLT readings, which is the usual failure mode when this board is mounted in the engine bay rather than the cabin.
Order the bare PCB from PCBWay and populate from the Digi-Key BOM published on the project page. If you are running this alongside a GMS gas management card, the Speeduino handles fuel and spark and the GMS handles the cell — do not try to make one board do both.
Get this board
Order the bare board direct from PCBWay: https://www.pcbway.com/project/shareproject/Speeduino_EFI_Shield_Mega_2560_Pro_Rev_1_4a__By_Don.html
Manuals, kits and assembled hardware — Secure Supplies shop: https://www.patreon.com/c/securesupplies/shop
Schematics, build support and the full library: https://www.patreon.com/c/securesupplies
Category: ECU / Speeduino / Hydrogen Hot Rod · Tags: Stanley Meyer, Water Fuel Cell, Hydrogen Hot Rod, PCBWay, ECU / Speeduino / Hydrogen Hot Rod
No comments:
Post a Comment