DROP BEAR SPEEDUINO V1 FILES ADDED
ECU / Speeduino / Hydrogen Hot Rod — Drop Bear is the next-generation controller — the board intended to replace both the Stanley Meyer GMS gas management unit and the ECU/EMS in a single Teensy-based platform.
The stated goal on the project page is to advance the Drop Bear to UNO Q and dual Teensy. In practice that means moving off the Arduino Mega's 8-bit core onto a Teensy 3.5, 3.6 or 4.1 as the primary controller, which gives you the clock speed and the hardware timers to run injection, ignition and cell gating from one board without the sequencing compromises the Mega forces.
The power section is specified for automotive abuse rather than bench use: a resettable polyfuse on the input, reverse-polarity protection by diode or MOSFET, a 12V to 5V/3.3V DC-DC buck rather than a linear regulator, 100uF 35V bulk capacitance and a full decoupling set close to every IC and regulator. TVS diodes go on the power rails and the exposed I/O, with series-resistor-plus-TVS protection on each ADC pin.
The I/O side is built per channel: level shifting or buffering on the cam, crank and hall inputs; MOSFET or IGBT drivers with dedicated gate driver ICs for each ignition and injector channel; fast-recovery flyback diodes on every inductive load. Sensor inputs get op-amp or level-shifter conditioning where the source impedance demands it. Everything exits on waterproof automotive connectors.
The files are on the project page. This is the most ambitious board in the library and the one to build if you intend to run gas management and engine management as one integrated system rather than two boxes talking over a harness.
Get this board
Order the bare board direct from PCBWay: https://www.pcbway.com/project/shareproject/DROP_BEAR_SPEEDUINO_V1_4260e213.html
Manuals, kits and assembled hardware — Secure Supplies shop: https://www.patreon.com/c/securesupplies/shop
Schematics, build support and the full library: https://www.patreon.com/c/securesupplies
Category: ECU / Speeduino / Hydrogen Hot Rod · Tags: Stanley Meyer, Water Fuel Cell, Hydrogen Hot Rod, PCBWay, ECU / Speeduino / Hydrogen Hot Rod
No comments:
Post a Comment